Working with Siemens Starter 4.3 for Sinamics G120 drives (Basic Commissioning)

Working  with Siemens Starter 4.3 for Sinamics G120 drives (Basic Commissioning)

Read through relevant manual thoroughly before working with the Drives.

DANGER!

• Commissioning / Maintenance must be performed only by qualified technicians.
• The emergency OFF functions must be fully operational during commissioning. The relevant safety regulations must be observed to exclude danger for man and machine.
• Incorrect details for the rated current or the maximum current can damage the motor!
A charge may still remain in the DC-link capacitor with hazardous voltages even if the power has been turned off. To avoid personal injury, please ensure that power has turned off before operating AC drive and wait ten minutes for capacitors to discharge to safe voltage levels.

CAUTION!

• There are highly sensitive MOS components on the printed circuit boards.
• These components are especially sensitive to static electricity. To avoid damage to these components, do not touch these components or the circuit boards with metal objects or your bare hands.
• The motor data identification should normally be performed when the motor is cold.

Important Note: Ensure that the IOP Connected  is of correct Firmware Prior Starting  Commissioning.

The Video below will guide you to configure the Sinamics G120 Drives with Siemens Starter

Software Version 4.3.

Please bear with the resolution of the Video as The recorder & Moviemaker doesnt work well together.

Read through the drives Manual to be Safe while working with Drives.